Audibox pro audio tools from ARX

Precision Tools for Audio Professionals

Remote Switcher	Model Options
Top/Front View Rear View	Remote Switcher Dual Channel unit with two sets of XLR inputs and one set of XLR outputs
Top/Front View Rear View	The new Remote Switcher silently switches between two pairs of A or B female XLR inputs to a stereo pair of XLR male output connectors.

More Audiboxes:

Blue DI

USB DI-Plus
(USB Plus Analog)

USB DI-Plus VC
(USB Plus Analog)

USB DI
USB DI-HP
USB DI-VC

USB ULTRA I/O

USB ULTRA VSR BROADCAST

USB DI-Q

SuperSplitter

ISO Balancer
ISO Balancer-VC

ISO Balancer DI

ISO Ultra De-Balancer

ISO Later
ISO Splitter
ISO Combiner
ISO Switcher
ISO Selector

Remote Switcher
Remote Selector

Q Switch

Pro DI
AV DI Plus

Remote Switcher

The simplest ideas are usually the best! ARX's new Remote Switcher is a stereo Input signal switcher for the extremely popular Audibox range.

ARX ‘SoftSwitch’ technology achieves this with no loud bangs through the audio system when switching.

Input Channel control can be selected in 2 ways:

Mode 1 by remote switch / relay closure (using an external power pack / wall wart), or
Mode 2 by 12 - 24VDC supplied from an EWIS panel or similiar.

Typical applications include switching between Audio Systems, and EWIS emergency announcements. With no DC voltage applied, Input A, the default normal audio signal is selected.

When +12 – 24VDC is applied to Pins 3 and 4 on the Dinkle type connector, then Input B, carrying Emergency announcements, or alarm signal etc is selected.

Another useful application is remotely switching between Live Band or DJ when both are using the same Audio Speaker system.

Note - Connectors are inserted in the top of the unit. Please allow adequate space above the Remote Switcher to allow for the connectors to be removed and / or replaced.

12 - 24 VDC Power required for Mode 1 usage

Precision engineered
Most of the Audibox range share a common footprint and manufacturing platform. Offset lid screws enable close side-by-side mounting of multiple units.

Hand Made in Australia

T E C H N I C A L || S P E C I F I C A T I O N S

Frequency Response: 10Hz to 50KHz + - .5dB

Power Requirements: DC Input +12 – 24 VDC Connector 2.5mm centre pin

Remote Switch and External Input: 4 Pin Dinkle type socket, 5mm pin spacing. Connector supplied with unit

Pin 1 and 2 Remote Switch – Open Input = Channel A selected, Closed Input = Channel B selected.
Pin 3 and 4 Remote DC control – Pin 3 +12 - 24VDC Pin 4 0VDC / Gnd

Connections:
Input Connectors: Female XLR, Wired Pin 1 Audio Ground, Pin 2 + Hot, Pin 3 – Cold

Output Connectors: Male XLR, Wired Pin 1 Audio Ground, Pin 2 + Hot, Pin 3 – Cold

Chassis Ground/Earth: Via Pin 1's on Left Channels

Construction: All-steel polyurethane coated chassis, fibreglass PCB

Operating Mode Schematics